Lutron LMJ-5T-DV-B 0-10 V Dimming for RadioRA 3

Professional-Grade 0-10 V Control

• 120/277 V Operation: The North American LMJ- model supports either voltage, 50/60 Hz. Typical power consumption under 1.0 W.

• Up to 5 A Switching: Controls compatible lighting loads within the module's rating.

• Up to 60 mA Control Link: Automatically configures to source or sink the 0-10 V signal.

• No Minimum Load: Lutron states no minimum load requirements on the switched output.

• High- and Low-End Trim: Configurable, to establish stable and useful dimming limits.

• Plenum Rated: UL 2043 plenum rated; complies with NEC 2011 300.22(C)(3) for compartments handling environmental air (LMJ- model only).

• Mounting: Mounts to an electrical junction box through a 1/2 in (21 mm) knockout. Some U.S. applications require the module to be installed inside an additional junction box, see Lutron Application Note #423.

• Wiring: Use 18 AWG to 16 AWG solid wire only for the 0-10 V control pair.

• RF Range: 30 ft from a RadioRA 3 processor or wireless repeater. Range can be extended with up to four wireless repeaters on a single RF link. Contact Lutron for applications using foil-backed or metallic ceiling tiles.

• Environment: 32 °F-104 °F, 0%-90% non-condensing humidity, indoor use only.

LMJ-5T-DV-B Design and Installation in NJ

This is not a homeowner plug-in accessory. It requires line-voltage wiring, neutral, a compatible fixture or driver interface, correct 0-10 V polarity, proper enclosure selection, and professional RadioRA 3 programming.

ynVISION designs and coordinates 0-10 V lighting control for custom homes, garages, utility areas, and specialty spaces throughout Short Hills, Millburn, Summit, Towaco, and Northern New Jersey.